![]() Following the same procedure to cut the other side. Use a hammer or a chisel to remove the rest of the material and smooth out the bottom of the notch with a sharp chisel to show and practice some wood working skill. Continue to run the saw between two guides a couple more times free handed to waste more material. Run the saw and cut along one guide, and flip the saw around and cut along the other guide from the opposite direction. Set the cutting depth of the saw to 2 1/4" for the (5) pieces of the cross supports, that's 2" deep notch plus 1/4" of the hard board thickness. Now the cut off notch between two trimmed guides will be exactly the width of the 2x4. Use two pieces of 2x4 cut off pieces as spacers, and place the other saw guide against them with the trimmed side, clamp it down as well. ![]() ![]() While the cross support of the table top still clamped together, place one of the saw guide onto the layout line, making sure the trimmed line is on the layout line and square to the 2x4, and clamp it down. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |